Check out the video above or the step by step guide below for assistance with this repair

iFixit MacBook Pro 13" Battery Replacement Guide

Here are some tools you may need to help you complete the repair.

• Mechanic AK-15 King ESD Anti-Static Stainless Steel Red Curved Tweezers
• iGadget Plastic Triangle Opening Picks (set of 5)
• uFix iOpener Microwaveable Heated Bag Opening Tool
• iGadget Plastic Alcohol 200mL Bottle with Pump Top
• iGadget Universal Magnetic Work Project Mat with Marker (30cm x 25cm)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair. A charged lithium-ion battery can catch fire or explode if punctured or damaged
• These MacBook Pros can power on by themselves when the bottom case comes off. Intel models: run sudo nvram AutoBoot=%00 in Terminal (sudo nvram AutoBoot=%03 afterwards). M1/M2 models on macOS Sequoia or later: sudo nvram BootPreference=%00 (sudo nvram -d BootPreference afterwards). Power down, then disconnect the battery before anything else
• The P5 pentalobe and T5 Torx screwdrivers you need are included in the box with this battery.
• Always track your screws to avoid putting back in the wrong place and damaging your device. You can draw a picture of your device and tape the screws to the right places or use a screw mat
• The bottom case is held by six P5 pentalobe screws and four hidden clips. Lift the front edge with a suction cup and release the clips with opening picks
• The trackpad has to come out to free the battery, and its cable is stuck to the battery. Warm the cable and peel it off slowly rather than pulling it
• The cells are glued down. Keep solvent off the display, keyboard and speakers with foil between keyboard and screen and a towel under the edge. Add adhesive remover or isopropyl alcohol under each cell, wait a few minutes, lift with plastic cards. Never pry cells with metal or bend them
• Remove all the old adhesive so the new battery sits flat and the bottom case closes properly
• The control board and flex come already fitted to the battery, so there is no board to transfer from your old battery.
• If your newly installed battery is draining fast or shutting off randomly, first try the battery calibration steps found here. If that doesn't resolve it, on Intel models (A1708, A2159, A2289) try an SMC reset; M1 and M2 models have no SMC reset - shut down, wait 30 seconds and restart