Check out the video above for assistance with this repair

Here are some tools you may need to help you complete the repair.

• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• #000 1.5mm Metal Phillips Screwdriver Tool (PH000)
• iSclack Evo (Gen 3) Suction Cup Opening Tool by Dottorpod
• Large Blue Suction Cup Opening Tool
• iGadget 5 piece opening picks
• 5x iGadget Plastic Flexible Opening Cards
• Nylon Antistatic Spudger Pry Tool
• uFix iOpener Microwaveable Heated Bag Opening Tool
• Box of Isopropyl Adhesive Cleaning Alcohol Pad Wipes x100
• 2mm Tesa Tape 61395 Roll Double Sided Adhesive Tape (100m)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Power the tablet off and take out the SIM / microSD card tray before you open it.
• The screen is glued to the front of the frame. Warm the edges gently with the iOpener in short bursts, as too much heat can damage the battery, then lift a corner with the suction cup or iSclack and work picks and cards around the edge, no more than 2 to 3mm in, or you can cut the flex cables under the edges.
• Lift the screen like opening a book, away from the side its flex cable is on, and never pull on the flex while it is still connected.
• Always track your screws (Phillips #00, with a #000 on hand for any smaller screws) so they go back in the right place. Draw a picture of your tablet and tape the screws to it, or use a screw mat
• Always unplug the battery before you remove any other parts. Keep metal tools away from the battery, and never bend, crush or puncture it.
• Unplug the display flex from the board with the spudger. When you connect the new one, press the connector down evenly at both ends, never in the middle, so the pins don't bend.
• Test the display and touch before you seal the screen in, and leave the protective film and stickers on until the new screen is working properly.
• Clean the old adhesive off the frame with isopropyl alcohol, fit a strip of 2mm Tesa tape all the way round the frame (no adhesive comes in the box), then press the screen down evenly so it sits flat, and keep even pressure on it (clamps or a flat weight) for a couple of hours while the adhesive sets.