Check out the video above for assistance with this repair

Here are some tools you may need to help you complete the repair.

• uFix iOpener Microwaveable Heated Bag Opening Tool
• iGadget 5 piece opening picks
• 5x iGadget Plastic Flexible Opening Cards
• Nylon Antistatic Spudger Pry Tool
• Box of Isopropyl Adhesive Cleaning Alcohol Pad Wipes x100
• 2mm Tesa Tape 61395 Roll Double Sided Adhesive Tape (100m)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Power the tablet off and take out the SIM / microSD card tray before you start.
• The screen is glued to the front of the frame and comes off from the front. Warm the edges gently with the iOpener in short bursts, as too much heat can damage the battery under the screen, then work picks and cards around the edge no more than 2 to 3mm in, so you don't cut the display flex.
• The battery stays connected for this repair. Keep the tablet powered off, keep metal tools away from the battery and board, and never bend, crush or puncture the battery.
• Lift the screen slowly and don't pull it away: the display flex is still connected underneath. Unplug it with the spudger, and when you connect the new one, press the connector down evenly at both ends, never in the middle, so the pins don't bend.
• Test the display and touch before you seal the screen in, and leave the protective film and stickers on until the new screen is working properly.
• Clean the old adhesive off the frame with isopropyl alcohol, fit a strip of 2mm Tesa tape all the way round the frame (no adhesive comes in the box), then press the screen down evenly so it sits flat.