Check out the video above for assistance with this repair

Here are some tools you may need to help you complete the repair.

• #000 1.5mm Metal Phillips Screwdriver Tool (PH000)
• iGadget 5 piece opening picks
• 5x iGadget Plastic Flexible Opening Cards
• iPlastix Flexible Opening Tool by Dottorpod
• Nylon Antistatic Spudger Pry Tool
• Mechanic AK-15 King ESD Anti-Static Stainless Steel Red Curved Tweezers
• uFix iOpener Microwaveable Heated Bag Opening Tool
• CPB 320 Repair Heat Pad for mobile phones and tablets
• Box of Isopropyl Adhesive Cleaning Alcohol Pad Wipes x100
• Dust Free Cleaning Cloth Wipes x50
• B7000 Multipurpose Liquid Repair Glue - 15ml
• 2mm Tesa Tape 61395 Roll Double Sided Adhesive Tape (100m)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Power the phone off and take out the SIM tray before you open it.
• The plastic back cover is held on by adhesive. Warm the edges gently with the iOpener in short bursts, as too much heat can damage the battery, then work a pick around the edge, no more than 3 to 5mm in, or you can cut the side key, antenna or camera cables.
• Always track your screws (Phillips #000) so they go back in the right place. Draw a picture of your phone and tape the screws to it, or use a screw mat
• Always unplug the battery before you remove any other parts. Keep metal tools away from the battery, and never bend, crush or puncture it.
• Unplug the screen flex from the board with the spudger, then warm the front of the old screen in short bursts on a heat pad or with the iOpener and work picks in from the edge, using an opening card or the iPlastix to hold the gap. Keep metal tools out, as they can cut the flex or gouge the frame. Feed the flex out through the frame as the screen lifts away.
• Pick the old adhesive off the frame with the tweezers, then clean every trace off with isopropyl alcohol and a dust free cloth so the new screen sits flat.
• Connect and test the new screen before gluing it in: feed its flex through the frame, plug it and the battery in, then check the display, touch, side-key fingerprint reader, cameras and calls before you unplug the battery again. Leave the protective film and stickers on until the new screen is working properly.
• Run a thin bead of B7000 around the frame, clear of the flex cutout, press the new screen down evenly and hold it with rubber bands or tape until the glue has set.
• Press the back cover down all the way round so it sits flat. If the old adhesive no longer holds, fit a strip of 2mm Tesa tape where it was.