Check out the video above or the step by step guide below for assistance with this repair

iFixit iPad Pro 12.9" 5th Gen Screen Replacement Guide

iFixit iPad Pro 12.9" 6th Gen Screen Replacement Guide

Here are some tools you may need to help you complete the repair.

• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• uFix iOpener Microwaveable Heated Bag Opening Tool
• CPB 320 Repair Heat Pad for mobile phones and tablets
• Large Blue Suction Cup Opening Tool
• iGadget Plastic Triangle Opening Picks (set of 5)
• 5x iGadget Plastic Flexible Opening Cards
• Nylon Antistatic Spudger Pry Tool
• Mechanic AK-15 King ESD Anti-Static Stainless Steel Red Curved Tweezers
• iGadget Plastic Alcohol 200mL Bottle with Pump Top
• B7000 Multipurpose Liquid Repair Glue - 15ml
• iGadget Universal Magnetic Work Project Mat with Marker (30cm x 25cm)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• The battery stays connected for this repair, so drain it below 25% and power the iPad off before you start. Keep metal tools away from the battery and board, and never bend, crush or puncture the battery
• The screen is glued all round. Tape over cracked glass, warm each edge with the iOpener or heat pad in short passes (too much heat can damage the battery), lift it with the suction cup and work opening picks round, keeping them shallow, as the display cables, sensors and antennas sit just inside the edge
• Track your screws on a magnetic mat, as they are different lengths. Remove the cable shield screws, then pry the display and sensor connectors up with the spudger. Refit press connectors by pressing one side then the other until they click, never the middle
• The display cables are not fitted to the new screen. Take the cable bracket off, unclip the display cables from your old screen and fit them to the new one before you connect it, keeping the connectors clean
• Move the top sensor assembly (two light sensors, the proximity sensor and the microphone) to the new screen: warm the top edge of the old screen, lift each part slowly with tweezers and stick it in the same spot on the new screen, using a little B7000 if its adhesive has gone
• Test touch, the picture, Face ID and auto-brightness before you seal it, and leave the protective film on until the new screen works
• Clean the old adhesive off the frame with isopropyl alcohol, peel the liner off the pre-fitted Tesa tape, line the screen up and press it down evenly all round, then hold it while the adhesive sets