Follow the step by step guide below for assistance with this repair

iFixit Samsung Galaxy S9 Plus Display Replacement Guide

Here are some tools you may need to help you complete the repair.

• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• uFix iOpener Microwaveable Heated Bag Opening Tool
• Large Blue Suction Cup Opening Tool
• iSclack Evo (Gen 3) Suction Cup Opening Tool by Dottorpod
• iGadget 5 piece opening picks
• 5x iGadget Plastic Flexible Opening Cards
• iPlastix Flexible Opening Tool by Dottorpod
• Nylon Antistatic Spudger Pry Tool
• Box of Isopropyl Adhesive Cleaning Alcohol Pad Wipes x100
• B7000 Multipurpose Liquid Repair Glue - 15ml
• 2mm Tesa Tape 61395 Roll Double Sided Adhesive Tape (100m)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Power the phone off and take out the SIM tray before you open it.
• The back glass is glued on. Warm the edges gently with the iOpener in short bursts, as too much heat can damage the battery, then lift a corner with the suction cup or iSclack and slice the adhesive with a pick no more than 3 to 5mm in, or you can cut the fingerprint, wireless charging coil or antenna cables. Unplug the fingerprint sensor cable before you lift the glass away, and go gently at the curved edges, where the glass can crack.
• Always track your screws (Phillips #00) so they go back in the right place. Draw a picture of your phone and tape the screws to it, or use a screw mat
• Always unplug the battery before you remove any other parts. Keep metal tools away from the battery, and never bend, crush or puncture it.
• Take out the screws holding the NFC antenna and wireless charging coil assembly and the motherboard cover, lift them out, then unplug the display cable with the spudger. The battery and board stay in the frame for this repair.
• Warm the screen in short bursts, then lift the old screen off the front with the suction cup, working plastic picks, an opening card or the iPlastix under it, keeping them shallow, and feed the display cable out through the slot in the frame. Use plastic tools only, never metal, against the OLED panel, and take extra care along the curved edges.
• Clean every trace of old adhesive and glass off the frame with isopropyl alcohol, so the new screen sits flat.
• Connect and test the new screen before gluing it in: check the display and touch, and leave the protective film and stickers on until the new screen is working properly.
• No adhesive comes in the box: glue the new screen in with a thin line of B7000 around the edge of the frame, keeping it out of the cable slot, and hold the screen pressed flat while it sets.
• Opening the phone breaks the factory seal. Fit new adhesive (a strip of 2mm Tesa tape where the old adhesive was) when you close up the back, or the phone will lose its water resistance rating.