Check out the video above for assistance with this repair

Here are some tools you may need to help you complete the repair.

• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• iGadget 5 piece opening picks
• 5x iGadget Plastic Flexible Opening Cards
• Nylon Antistatic Spudger Pry Tool
• Box of Isopropyl Adhesive Cleaning Alcohol Pad Wipes x100

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Power the phone off and take out the SIM tray before you open it.
• The plastic back cover clips on. Start with a pick below the volume buttons, release the clips no more than 3 to 5mm in, and open the cover like a book: the side-key fingerprint cable is still attached, so take out the screws over its connector and unplug it before you lift the cover away.
• Always track your screws (Phillips #00) so they go back in the right place. Draw a picture of your phone and tape the screws to it, or use a screw mat
• Always unplug the battery before you remove any other parts. Keep metal tools away from the battery, and never bend, crush or puncture it.
• Move the motherboard, bottom board, cameras, vibration motor and flex cables from your old frame into the new one, unplugging each cable with the spudger. The battery is not included and is glued in: loosen its adhesive with isopropyl alcohol and lift it slowly with a plastic card, never prying against the cell, or fit a new battery.
• Test the display, touch, side-key fingerprint reader, cameras and calls before you close the phone up, and leave the protective film and stickers on until the new screen is working properly.
• Plug the fingerprint cable back in, then press the back cover down all the way round until every clip clicks in, so it sits flat.