Check out the video above or the step by step guide below for assistance with this repair

iFixit MacBook Air 13" 2022 (M2) Battery Replacement Guide

Here are some tools you may need to help you complete the repair.

• T4 Metal Torx Screwdriver Tool
• Mechanic AK-15 King ESD Anti-Static Stainless Steel Red Curved Tweezers
• 5x iGadget Plastic Flexible Opening Cards
• iGadget Plastic Alcohol 200mL Bottle with Pump Top
• iGadget Universal Magnetic Work Project Mat with Marker (30cm x 25cm)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair. A charged lithium-ion battery can catch fire or explode if punctured or damaged
• These MacBook Airs can power on by themselves when the lid opens or a charger is connected. On macOS Sequoia or later, run sudo nvram BootPreference=%00 in Terminal (undo afterwards with sudo nvram -d BootPreference). Power down, and on older macOS keep the lid closed until the battery is disconnected
• The P5 pentalobe, T3 and T5 Torx screwdrivers are included in the box. The tray screws are 4IP and 3IP Torx Plus, which a T4 and T3 turn with firm downward pressure
• Always track your screws to avoid putting back in the wrong place and damaging your device. You can draw a picture of your laptop and tape the screws to the right places or use a screw mat
• The bottom case is held by four P5 pentalobe screws. Lift the front edge with a suction cup, release the four snap clips with a pick, then pull the case straight back to free the tabs at the rear. The case edges are sharp
• Before any component removal, remove the battery connector cover (two 1.5 mm screws) and lift the press connector with a pick. Then remove the trackpad cable cover and peel the trackpad cable off the battery without creasing it
• iFixit's M2 guide takes the logic board out to reach the battery cable. Apple's M3 procedure slides the cable out from under the board instead
• Remove the four battery tray screws (two 4IP at the upper edges and two 3IP in the centre), then pull each stretch-release strip slowly at a shallow angle. If one snaps, add a few drops of isopropyl alcohol at the edge, wait a minute and slide a plastic card under the metal tray
• Handle the battery by its tray and don't bend it. Never pry against a cell with metal tools, and never bend, squeeze or puncture the cells when removing the old battery or fitting the new one
• The new adhesive strips come in the box and are not pre-attached. Fit them to the new battery before you put it in
• If your newly installed battery is draining fast or shutting off randomly, first try the battery calibration steps found here. Apple silicon Macs have no SMC reset - shut down, wait 30 seconds and restart