Check out the video above for assistance with this repair

Here are some tools you may need to help you complete the repair.

• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• uFix iOpener Heat Bag
• Suction Cup
• iGadget 5 piece opening picks
• 5x iGadget Plastic Flexible Opening Cards
• Black Spudger
• Fine Tipped Curved Tweezers
• Amtech NC-559-ASM No-Clean Soldering Flux
• 10mm Heat Resistant Polyimide (Kapton) Board Repair Tape
• Isopropyl Adhesive Cleaning Alcohol Pad Wipes
• 4mm Tesa Tape 61395 Double Sided Adhesive Tape

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Always power down your device prior to working on it, and take out the SIM card tray first.
• Always track your screws to avoid putting back in the wrong place and damaging your device. You can draw a picture of your phone and tape the screws to the right places or use a screw mat
• The back glass is glued on. Warm each edge with the iOpener in short bursts, lift it with the suction cup and slice the adhesive with opening picks. Do not overheat the phone, as heat damages the screen and the battery.
• Only push an opening pick 4 to 5mm past the edge. Any deeper and you can cut the antenna cable, the power button cable or the rear cameras.
• The top plastic cover (with the NFC and wireless charging coil) and the lower cover (with the loudspeaker) have to come off to reach the main board. Do not tear the coil cable, and press every connector back down until it clicks.
• Make sure you always unplug the battery before attempting any component removal
• Unclip the display, headphone jack and aerial (coaxial antenna) cables before lifting the main board out. Slide the board toward the top of the phone to free the USB-C port from its opening, and reconnect every cable when refitting, or the phone may lose signal after the repair.
• The USB-C socket is soldered to the main board. Cover nearby parts with Kapton tape, use plenty of flux, and keep the hot air moving so you do not lift pads or melt the plastic parts close to the port.
• Power on and test charging and a computer connection before you seal the back.
• Opening the phone breaks the factory seal. Clean off the old adhesive with alcohol and fit new adhesive when you close it up, or the phone will lose its water resistance rating.