Check out the video above or the step by step guide below for assistance with this repair

Samsung Galaxy Note9 Charging Assembly Replacement Guide

Here are some tools you may need to help you complete the repair.

• #000 1.5mm Metal Phillips Screwdriver Tool (PH000)
• uFix iOpener Heat Bag
• Suction Cup
• iGadget 5 piece opening picks
• 5x iGadget Plastic Flexible Opening Cards
• Black Spudger
• Fine Tipped Curved Tweezers
• Isopropyl Adhesive Cleaning Alcohol Pad Wipes
• 4mm Tesa Tape 61395 Double Sided Adhesive Tape

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Always power down your device prior to working on it, and take the S Pen and the SIM tray out first
• Always track your screws to avoid putting back in the wrong place and damaging your device. You can draw a picture of your phone and tape the screws to the right places or use a screw mat
• The back glass is glued on. Warm each edge with the iOpener in short bursts, lift it with the suction cup and slice the adhesive with opening picks. Do not overheat the phone, as heat damages the screen and the battery.
• Only push an opening pick 4 to 5mm past the edge. Any deeper and you can cut the fingerprint sensor cable on the back glass or damage the rear cameras.
• Unplug the fingerprint sensor cable before you lift the back glass fully away.
• The wireless charging coil is stuck to the upper midframe. Peel it off slowly so you do not tear it, and stick it back once the midframe is in.
• Make sure you always unplug the battery before attempting any component removal
• On the Note 9 the charging port board sits under the main board, so the main board has to come out. Unclip the display, touchscreen, front camera, iris scanner and charging board cables first, including any aerial (antenna) cable. When refitting, press each connector back down until it clicks, or the phone may lose charging, signal or display.
• The microphone on the end of the old board sits in a rubber housing in the frame. Lift it out with the board, and seat the new board's microphone in the same housing.
• Power on and test charging and the microphone before you seal the back.
• Opening the phone breaks the factory seal. Clean off the old adhesive with alcohol and fit new adhesive when you close it up, or the phone will lose its water resistance rating.