Check out the video above for assistance with this repair

Here are some tools you may need to help you complete the repair.

• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• uFix iOpener Heat Bag
• Suction Cup
• iGadget 5 piece opening picks
• 5x iGadget Plastic Flexible Opening Cards
• Black Spudger
• Fine Tipped Curved Tweezers
• Isopropyl Adhesive Cleaning Alcohol Pad Wipes
• 4mm Tesa Tape 61395 Double Sided Adhesive Tape

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Always power down your device prior to working on it, and take the S Pen out first
• Always track your screws to avoid putting back in the wrong place and damaging your device. You can draw a picture of your phone and tape the screws to the right places or use a screw mat
• The back glass is glued on. Warm each edge with the iOpener in short bursts, lift it with the suction cup and slice the adhesive with opening picks. Do not overheat the phone, as heat damages the screen and the battery.
• Only push an opening pick 4 to 5mm past the edge. Any deeper and you can cut the antenna cable, the power button cable or the rear camera.
• The NFC and wireless charging plate has to come out to reach the charging port flex. Do not tear its cable, and press its connectors back down until they click.
• Make sure you always unplug the battery before attempting any component removal
• The flex is glued down. Lift it slowly with a spudger so it does not tear, and line up the touch key contacts before you press the new one down.
• Power on and test charging, wired headphones and the Back and Recent apps keys before you close the phone.
• Clean off the old adhesive with alcohol and stick the back glass down with new adhesive. The Note 5 is not water resistant, so the adhesive is there to hold the glass on.