Follow the step by step guides below for assistance with this repair

iFixit Retina MacBook 2015 USB-C Port Replacement Guide

iFixit Applying Low Voltage After Every Repair (Retina MacBook 2015)

Here are some tools you may need to help you complete the repair.

• P5 Metal Pentalobe 1.2mm Screwdriver Tool
• T5 Torx Screwdriver | MacBook Logic Board and Battery Repairs
• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• Y00 Metal Triwing Tri-Point 1.5mm Screwdriver Tool
• Or get the P5 and T5 together in our 10 Piece MacBook Repair Toolkit
• Mechanic AK-15 King ESD Anti-Static Stainless Steel Red Curved Tweezers
• Nylon Antistatic Spudger Pry Tool
• iGadget Universal Magnetic Work Project Mat with Marker (30cm x 25cm)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Always power down your device prior to working on it
• The eight P5 bottom case screws are three lengths. Track your screws on a magnetic work mat or tape them to a drawing of your laptop, as several screws look alike but are different lengths
• Disconnect the battery by holding the small battery disconnect button down with a spudger until the power light goes out, then remove the T5 battery connector screw
• Don't lay the case open flat. Prop the top half at about 90 degrees so the cables joining the halves don't tear
• The USB-C cable bracket is held by a T5 screw and a Y00 tri-point (a #00 Phillips on some units). The flex has one #00 Phillips screw and a small metal bracket whose tab must slide back into its slot
• Refit the silver ground clip and its two foam pads under the battery connector screw with tweezers
• Before the first power-on, connect a 5 W iPhone charger through a USB-C to USB-A cable. iFixit recommends this low-voltage start after every repair on the 2015 12" MacBook