Check out the video above or the step by step guide below for assistance with this repair

iFixit iPhone 11 Pro Lightning Connector Assembly Replacement Guide

Here are some tools you may need to help you complete the repair.

• P2 Metal Pentalobe 0.8mm Screwdriver Tool
• Y000 Metal Triwing Tri-Point 0.6mm Screwdriver Tool
• #000 1.5mm Metal Phillips Screwdriver Tool (PH000)
• Large Blue Suction Cup Opening Tool
• Mechanic AK-15 King ESD Anti-Static Stainless Steel Red Curved Tweezers
• iGadget Plastic Triangle Opening Picks (set of 5)
• 5x iGadget Plastic Flexible Opening Cards
• Nylon Antistatic Spudger Pry Tool
• Or get the P2, Y000 and #000 screwdrivers, suction cup, tweezers, opening pick, opening card and spudger together in our 8 Piece iPhone Repair Toolkit
• Metal Stand-Off 2.5mm Screwdriver Tool
• iSclack Evo (Gen 3) Suction Cup Opening Tool for phones and tablets by Dottorpod
• uFix iOpener Microwaveable Heated Bag Opening Tool
• iHold Evo Screen Holding Opening Tool for iPads and iPhones with USB-C Adapter by Dottorpod
• iGadget Plastic Alcohol 200mL Bottle with Pump Top
• iPhone 11 Pro OLED Screen Gasket Adhesive

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Always power down your device prior to working on it
• Track your screws, they are different types and lengths: two P2 pentalobe screws beside the Lightning port, Y000 tri-point screws on the brackets, and Phillips #000 and standoff screws on the loudspeaker and charging port. Use a screw mat to keep them in place
• Remove the two pentalobe screws, warm the bottom edge and lift the screen with a suction cup. Slide picks under the plastic bezel, no more than 3mm deep, and keep them out of the right edge where the display cables run. The screen opens like a book, hinged on the right, with clips along the top edge
• Make sure you always unplug the battery before attempting any component removal. On the iPhone 11 Pro unplug the battery connector under its bracket at the top, then the lower battery flex under its cover beside the Taptic Engine
• To reach the charging port, remove the Taptic Engine and the loudspeaker. The loudspeaker is sealed to the frame with a gasket, so warm it before lifting it out
• The microphone sits under a small cover held by a Y000 screw and light adhesive. Warm it, lift the microphone out with tweezers, and note how the microphone and logic board flex cables are folded so you can fold the new port the same way
• The connector to the logic board can be tricky to align correctly so it fits into place. We recommend taking a pencil and tracing the original charging port so you know exactly where it gets positioned, then lining the new charging port up within the pencil lines
• Move any foam pads across from the old charging port to the new one, and refit every grounding screw
• Reconnect the battery and screen and test charging, a computer connection and the microphone (record a voice memo) before sealing the phone
• Opening your iPhone 11 Pro breaks its factory water-resistance seal. Clean off the old adhesive with isopropyl alcohol and fit new display adhesive when you reassemble it