Here are some tools you may need to help you complete the repair.

• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• Suction Cup
• Fine Tipped Curved Tweezers
• Dottorpod iFlex Metal Opening Tool
• Dottorpod iPlastix Opening Tool
• iGadget 5 piece opening picks
• Black Spudger
• uFix iOpener Heat bag
• Heat Gun
• 4mm Tesa Tape 61395 Roll Double Sided Adhesive Tape (50m)
• 5x iGadget Plastic Flexible Opening Cards

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Always track your screws to avoid putting back in the wrong place and damaging your device. You can draw a picture of your phone and tape the screws to the right places or use a screw mat
• Always power down your device prior to working on it
• Make sure you always unplug the battery before attempting any component removal
• Be careful not to push an opening tool too far past the adhesive, the wireless coil is easily pierced or sliced
• Opening the phone breaks the factory seal. Fit new adhesive when you close it up or the phone will lose its water resistance rating.
• Do not overheat the phone. The screen and the battery are both damaged by heat, so work in short bursts and keep the heat moving.
• Only push an opening pick 3 to 5mm past the edge. Any deeper and you can cut the antenna cable, the power button cable or the rear cameras.
• Use plastic tools only near the battery. Never bend, crush or puncture it.
• The fingerprint reader is part of the screen on newer models and may need setting up again after the repair.