Watch the checkout the above video for assistance in completing this repair

Here are some tools you may need to help you complete the repair.

• #00 Metal Phillips 2.0mm Screwdriver Tool (PH00)
• Suction Cup
• Fine Tipped Curved Tweezers
• Dottorpod iFlex Metal Opening Tool
• Dottorpod iPlastix Opening Tool
• iGadget 5 piece opening picks
• Black Spudger
• uFix iOpener Heat bag
• Heat Gun
• 4mm Tesa Tape 61395 Roll Double Sided Adhesive Tape (50m)
• 5x iGadget Plastic Flexible Opening Cards

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Always track your screws to avoid putting back in the wrong place and damaging your device. You can draw a picture of your phone and tape the screws to the right places or use a screw mat
• Always power down your device prior to working on it
• Make sure you always unplug the battery before attempting any component removal
• Be careful not to push an opening tool too far past the adhesive, the wireless coil is easily pierced or sliced
• Opening the phone breaks the factory seal. Fit new adhesive when you close it up or the phone will lose its water resistance rating.
• Do not overheat the phone. The screen and the battery are both damaged by heat, so work in short bursts and keep the heat moving.
• Only push an opening pick 3 to 5mm past the edge. Any deeper and you can cut the antenna cable, the power button cable or the rear cameras.
• Use plastic tools only near the battery. Never bend, crush or puncture it.
• Move the motherboard, charging board, cameras, speakers, wireless charging coil and antennas from your old frame into the new one. The battery is not included, so transfer your old one (isopropyl alcohol helps loosen its adhesive) or fit a new one.
• The fingerprint reader is part of the screen on newer models and may need setting up again after the repair.