Check out the video above or the step by step guide below for assistance with this repair

iFixit MacBook Pro 14" A2442 2021 Screen Replacement Guide

iFixit MacBook Pro 14" A2779 2023 Screen Replacement Guide

iFixit MacBook Pro 14" A2918 and A2992 Late 2023 Screen Replacement Guide

Here are some tools you may need to help you complete the repair.

• P2 Metal Pentalobe 0.8mm Screwdriver Tool
• P5 Metal Pentalobe 1.2mm Screwdriver Tool
• T3 Metal Torx Screwdriver Tool
• T5 Metal Torx Screwdriver Tool
• T8 Torx Security Screwdriver Tool
• Or get the P2, P5, T3, T5 and T8 together in our 10 Piece MacBook Repair Toolkit
• Large Blue Suction Cup Opening Tool
• iGadget Plastic Triangle Opening Picks (set of 5)
• Nylon Antistatic Spudger Pry Tool
• Mechanic AK-15 King ESD Anti-Static Stainless Steel Red Curved Tweezers
• iGadget Universal Magnetic Work Project Mat with Marker (30cm x 25cm)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Turn off Auto Boot first so the MacBook does not power on mid-repair (iFixit guide). On macOS Sequoia 15 or later, enter sudo nvram BootPreference=%00 in Terminal, and sudo nvram -d BootPreference to undo it afterwards (Apple guide). On older macOS, keep the lid closed while you work. Then power down
• Always track your screws to avoid putting them back in the wrong place and damaging your device. Draw a picture of your laptop and tape the screws to the right places, or use a magnetic work mat
• Apple uses Torx Plus screws inside (3IP, 5IP and 8IP on the M2 and M3 models). Our same-size T3, T5 and T8 drivers turn them, but they sit with a little play, so press down firmly and turn gently
• The bottom case is held by P5 screws and clips. Lift the back edge with the suction cup, release the clips with a pick, then slide the case off
• Always unplug the battery before you remove any other parts. Keep metal tools away from the battery, and never bend, crush or puncture it.
• The antenna bar comes out (tiny P2 screws) and the screen cables and lid-angle sensor cable unplug. Lift the connectors with the spudger and small cables with tweezers
• Remove the hinge covers, then support the display at 90 degrees while you remove and refit the hinge screws
• Make sure you route the screen cables correctly so they don't get pinched by the hinge
• Don't peel off the protective film or any stickers until you've tested the new screen and it's working properly.
• Reconnect the antenna cables after refitting the antenna bar, or Wi-Fi and Bluetooth will be weak