Check out the video above or the step by step guide below for assistance with this repair

iFixit MacBook Pro 13.3" A2338 Complete Screen Replacement Removal Guide (M1 2020)

iFixit MacBook Pro 13.3" A2338 Display Assembly Replacement Guide (M2 2022)

Here are some tools you may need to help you complete the repair.

• P2 Metal Pentalobe 0.8mm Screwdriver Tool
• P5 Metal Pentalobe 1.2mm Screwdriver Tool
• T3 Metal Torx Screwdriver Tool
• T5 Metal Torx Screwdriver Tool
• T8 Torx Security Screwdriver Tool
• Or get the P2, P5, T3, T5 and T8 together in our 10 Piece MacBook Repair Toolkit
• Large Blue Suction Cup Opening Tool
• iGadget Plastic Triangle Opening Picks (set of 5)
• Nylon Antistatic Spudger Pry Tool
• Mechanic AK-15 King ESD Anti-Static Stainless Steel Red Curved Tweezers
• iGadget Universal Magnetic Work Project Mat with Marker (30cm x 25cm)

Here are some helpful tips to assist you in completing a safe repair on your device. If you are unsure of something or have any questions, please feel free to contact us either by phone (0508 IGADGET) or by email

• Drain the battery below 25% before you start on this repair
• Turn off Auto Boot first so the MacBook does not power on mid-repair (iFixit guide). On macOS Sequoia 15 or later, enter sudo nvram BootPreference=%00 in Terminal, and sudo nvram -d BootPreference to undo it afterwards (Apple guide). On older macOS, keep the lid closed while you work. Then power down
• Always track your screws to avoid putting them back in the wrong place and damaging your device. Draw a picture of your laptop and tape the screws to the right places, or use a magnetic work mat
• Remove the P5 bottom case screws, then lift the front of the bottom case with the suction cup and slide a pick under the edge to release the clips. Do not slide the pick sideways, as two display cables run close to the edge
• Peel back the tape and flip up the battery data connector, then remove the T5 screw and lift the battery power connector with the spudger. Always unplug the battery before you remove any other parts. Keep metal tools away from the battery, and never bend, crush or puncture it.
• Remove the antenna bar (12 tiny P2 screws). Press firmly and turn gently so the heads don't round off, and lift the antenna cables straight up with tweezers
• The spring hinges are held by T3 screws and lift out with tweezers. Refit them correctly so the display flex stays tensioned
• Route the LCD and camera cables so they don't get pinched by the hinge, and click both antenna cables back in, or Wi-Fi and Bluetooth will be weak
• Test the screen, camera and Wi-Fi before you refit the bottom case, and leave the protective film and stickers on until the new screen is working properly.
• If the hinge clicks after reassembly, loosen the T8 hinge screws, re-align the display and tighten them again